What to Check Before Removing a Rear Wiper Cover

Locate the joint where the blade meets the arm, then check the exact vehicle procedure. The cover at the arm’s base and the parts at the blade joint can have different jobs.

Listen to the checklist. Narration is synthetic.
Read the transcript

Locate two points: the base where the rear arm turns, and the joint where the blade meets the arm. Check the blade replacement picture for your exact vehicle. Move a cap only as shown and support the arm as instructed. If the part resists or the diagram looks different, photograph the joint and get the attachment identified before trying again.

Identify which part you are looking at

With the vehicle parked and the rear wiper switched off, follow the arm from the liftgate to the middle of the blade. The part nearest the glass where the arm turns is the arm’s pivot. The blade connection is farther along the arm. A plastic cover by the pivot can look like something to release even though your task is at the blade connection.

Find the drawing for the blade you are replacing

Use the owner’s manual for the exact model and year. Look up rear blade replacement and find the illustration that shows where to hold the arm and how far it moves. Honda’s HR-V procedure is one example of a model-specific pivot-style release. Compare the drawing with your rear assembly before applying pressure. Some vehicles use a different connector or describe replacing the wiping rubber separately.

Stop if the cap or arm does not move as shown

Keep one hand on the arm when instructed to lift it. A spring-loaded arm can strike the glass if it drops. If the instructions leave the base cover in place, keep it in place. When a diagram calls for moving a cover, follow the indicated direction and release point. If the part resists or the illustration disagrees with the arm, take a side and top photo and get the connector identified before continuing.

Sources and next steps

Comment form title