How to Photograph a Wiper Connector for Fitment Help

Take an overhead and side photo of the joint where the wiper blade meets the arm. Include the vehicle’s model year, make and model, and say which position you photographed.

Listen to the checklist. Narration is synthetic.
Read the transcript

Park and turn the wipers off. Take one photo from above and one from the side where the blade meets the arm. Name the blade position and include the year, make, model and product link. If you can see the rear cover but cannot see the joint, send a wider photo and keep the cover in place until you have the proper instructions.

Take two photos of the same joint

Park safely. Set the wipers to off and keep the arm in its normal parked position when possible. From above, photograph the whole connection between the blade and metal arm. Frame it tightly enough to show a button, opening or latch. From the side, show the path where the arm enters the blade or adapter. A soft light from the side makes edges easier to see on dark plastic.

On a covered rear joint, start with what you can see from outside. Take a wider picture of the rear arm and liftgate so the position is recognizable. Avoid prying off a cover for a better view. If the front edge sits under the hood and you need more room, use the service-position instructions for that car.

Give the photo a name the reviewer can use

Label each pair of photos “driver front,” “passenger front” or “rear.” If you know an arm was replaced, say so. Send a photo of the new kit label or add the listing link. This lets support compare the joint to the exact product you are considering. Keep the crop centered on the joint and leave plates and paperwork outside the image.

Copy this note when asking for help

Vehicle
Model year, make, model and body style
Blade position
Driver front, passenger front or rear
Product
Listing link or SKU, if known
Photos
One overhead and one side view of the connection

If both front sides look different, take a separate photo pair for each side.

Sources and next steps

Comment form title