A split at the wiping edge calls for a blade inspection. Check for loose rubber and signs of holder damage, then choose a compatible blade or a refill specified for that holder.
Read the transcript
Switch off the wipers and use the access procedure for your vehicle. Look closely at the rubber edge and the holder. For a split or loose edge, check whether the fitted blade has a specified refill or takes a complete replacement. Check the other blade for wear while it is accessible. After replacement, make a short test on wet glass.
Find where the damage starts
Park the car and switch off the wipers. Use the manual’s service position if it is required for access. Look at the fine rubber edge that touches the glass. See whether it is torn, coming out of its track, or merely carrying a small piece of debris. Inspect the holder and its end pieces for damage as well. Support the arm and keep broken or loose hardware away from the glass.
Choose the replacement the holder accepts
Toyota’s RAV4 maintenance guide calls for inspection of the blades for wear or cracking. If there is a split or the rubber is loose, check the replacement procedure for your vehicle and the blade that is fitted now. Some designs have a specified rubber insert and retention method. With a damaged holder or a design without a serviceable insert, confirm the correct complete blade for that position and attachment.
Check the other blade while you have access
Look for breaks or a distorted edge on the adjacent blade. Blades can wear at different rates, so use each condition check when deciding what to replace. After fitting the replacement, wet the glass and run a short parked test. If the wipe still leaves a mark in the same spot, look at the glass in that area and recheck the seating.