How to Tell Which Front Wiper Goes on Each Side

Use the driver and passenger markings in the vehicle’s fitment listing and kit instructions. On U.S. left-hand-drive cars, the driver position is on the vehicle’s left when you are seated facing forward.

Listen to the checklist. Narration is synthetic.
Read the transcript

Use the car’s point of view when a label says left or right. On a U.S. left-hand-drive car, left is the driver side. Then read the kit’s position labels. Check the connector and any orientation marking separately, and compare the new blade with the old blade from the same position.

Use the car’s point of view

Identify left and right from the driver’s seat with the car facing forward. If you are standing at the front of the hood looking at the windshield, the vehicle’s left is on your right. A simple way to avoid mixing up the two is to write “driver” and “passenger” on separate slips of paper and place the new blades on them before you start.

Use the packaging to assign the lengths

Read the position labels or the application table for your exact kit. For example, Wowiper’s listed 2017–2022 Honda CR-V set puts its 26-inch blade at the driver front and its 17-inch blade at the passenger front. Even if another vehicle uses the same two lengths, check its listing for the correct positions and connectors.

With two blades of equal length, use the labels and installation diagrams. Pay attention to any front-left or front-right marking and the direction specified for a spoiler or adapter. Ask for clarification if two pieces appear identical and the instructions specify different positions.

Compare one front position at a time

Keep the original blade at that position next to the new one for a quick visual comparison. Verify the mounting point and lock as well as the overall length. When both blades are secured, return the arms to their normal resting positions according to the vehicle manual. Check that both sweep clear on wet glass while the car is parked. If a blade strikes the other blade or the trim, stop and recheck the positions and fit.

Sources and next steps

Comment form title