Lay the driver, passenger and rear blades out by position before removing the old ones. Compare the kit’s markings, adapters and instructions with the car.
Read the box before removing a blade
Match the part number on the packaging to the listing you ordered. Look for a diagram or a label that names the positions. Set out the driver-side, passenger-side and rear blades in that order. Keep any included adapters with the set and keep the instructions within reach.
Check the rear blade separately
A rear blade normally attaches to a different arm than the two front blades. Look for the exact clip, pivot or adapter called out in the rear instructions. If the kit has more than one adapter, identify which one is meant for the arm before taking anything off. A piece that resembles a spare should stay with the kit until you understand its purpose.
Use the video as an orientation
The demonstration above comes from the Wowiper installation guide. Use it to get a sense of the work area and the order of checks. At the vehicle, follow your owner’s manual and the instructions supplied with the exact kit. Those documents determine the correct arm position, release and locking action.
Keep the comparison easy once you start
Work on one position at a time. Keep the corresponding old blade nearby so you can compare the attachments. Hold the arm while it is off the glass and stop if the new connection does not seat as shown in the instructions. Once the blades are correctly fitted and the hood is closed, follow the vehicle guidance to test them on wet glass while parked.