Check whether a film is installed on the inside. Follow the film maker’s waiting time and permitted cleaner, and use a clean, soft cloth once the film is ready.
Read the transcript
Check the installer paperwork for the film and cure time. Follow the approved cleaner instructions and use a soft clean cloth without abrasives. Keep excess liquid away from switches and trim. Check the vehicle manual for rear defroster care. If the film lifts or bubbles, ask the installer before cleaning it again.
Identify the film and how recently it was installed
Check the installer paperwork to see whether the window has an aftermarket film and what care instructions came with it. If it was recently installed, wait for the stated cure period before cleaning or using the window as described. Different film products can have different aftercare guidance. When you are uncertain what is on the glass, ask the installer to identify it before choosing a cleaner.
Use the tools and cleaner allowed for that film
Check the film instructions and vehicle guidance together. XPEL’s instructions for its PRIME film, for example, recommend a soft microfiber cloth and advise against abrasives. Start with a clean soft cloth, follow the label and avoid allowing liquid to run into switches or trim. Use light pressure and keep grit away from the film. Follow any rear defroster and antenna precautions in your vehicle manual.
Look again after the glass dries
Inspect the glass under angled light. If a mark remains, check whether it sits outside or under a film edge before cleaning again. Contact the installer when there is lifting, bubbling or a stubborn mark on the film itself. Keep the cloth dedicated to glass so it stays free of polish and grit from other surfaces.