Before entering an automatic car wash, check the vehicle manual and set the wipers to the correct OFF position or the prescribed car-wash mode.
Read the transcript
Before entering an automatic wash, review your vehicle’s car wash instructions. Set the front wipers fully off, or use the mode specified by your manual. Check the rear wiper as well. Turning off rain sensing can leave intermittent wiping active on some cars, so also confirm the stalk is in the correct position.
Find the full OFF setting before entering
On a vehicle equipped with rain-sensing wipers, water at the sensor can trigger a wipe. Ford’s owner guidance tells drivers to switch the windshield wipers off before entering a wash. Check your model’s manual for the required position, because the labels and controls vary.
Some vehicles let you turn off rain sensing while keeping an intermittent setting active. Verify the stalk position as well as any screen setting. A low sensitivity setting can still allow the wipers to move. If your car has a dedicated car-wash mode, check what it controls and follow the manual’s instructions for that mode.
Use these checks at the entrance
- While stopped in the staging area, confirm the front wipers are off according to the owner’s manual.
- Check the rear wiper switch and follow the vehicle and wash operator’s instructions for the rear arm.
- Use the wash operator’s instructions for using the facility alongside your vehicle manual for car-wash mode, gear selection and ignition. Ask the attendant before entering if the instructions are unclear.
Restore your preferred setting after the wash
Wait until you have left the equipment. Check that the blades look seated and the arms are in their normal positions. Restore the preferred wiper setting when it is safe to do so. If a blade looks loose, stop in a safe place and inspect it before operating the wipers.