A repeatable unwiped band needs a position-specific check of the blade edge, attachment, application, and contact with the glass. Record where the gap appears before deciding to replace another blade. A narrow damaged section and a broad area losing contact are different observations.
Record the pattern first
With the vehicle parked, note whether the gap appears at the tip, near the middle, or over most of the sweep. Note whether it appears on both directions of travel. If visibility is inadequate, do not rely on another road test to collect this information.
| Observation | Useful next check |
|---|---|
| Same narrow line each pass | Inspect the corresponding section of the wiping edge |
| Broad missing area | Verify application, seating, and visible contact |
| Change after glass or arm work | Give that history to the workshop |
Inspect without reshaping the blade
Look for a split, missing piece, displaced rubber, or a connector that has not reached its retained position. Check the exact replacement application. Do not bend the blade to close a gap or press on the arm while the wipers are moving.
Valeo's technical reference identifies damaged rubber, distorted arms, and weak or broken arm springs among causes of lost contact. It also calls for the correct connector and a clean wiping area. A persistent band is therefore a reason to inspect the whole contact arrangement, not proof that a particular blade material is unsuitable.
Clean, then make one controlled check
Follow the vehicle and blade guidance for cleaning the glass and edge. Remove loose debris before testing on clear, wet glass. Keep a record of whether the pattern changes, rather than cycling through several cleaners and new blades at once.
When to involve a workshop
If the blade application and installation are correct but the gap remains, have the arm and contact checked. Bosch's checklist specifically notes checking contact pressure and angle after windshield replacement. That is a workshop check, not a direction to twist the arm at home.
Use the Wowiper installation guide when checking a recently fitted connector. If the issue is a film across the glass rather than a missing wipe area, read the streaks-after-cleaning guide for the separate glass-cleaning checks.