How to Prepare the Windshield Before Fitting New Wipers

Start with clean exterior glass before fitting the new blades. Remove loose dirt, clean with a method suitable for your vehicle, and use the first wet sweep to check the result.

Listen to the checklist. Narration is synthetic.
Read the transcript

With your car parked, turn off the wipers, including any automatic setting. Remove loose leaves and rinse away grit. Follow your vehicle’s glass care instructions and check the label on any cleaner. Use a clean cloth and keep the installation area clear. After fitting the blades, test briefly on wet glass while parked.

Prepare the exterior surface with the wipers off

Park in a suitable place and turn the wiper system off before working by the arms. If your vehicle has an automatic setting, follow the manual’s instruction for switching it off. Remove loose leaves and rinse away grit before putting a cloth on the windshield. Pay attention to the lower strip of glass the blades cross when they leave their parked position.

Use the glass care guidance for your car

Follow the vehicle’s cleaning instructions and the label on your glass product. Use a clean, soft cloth for any permitted wiping and change to a clean face if the cloth collects dirt. If the exterior has a special coating or treatment, check what it allows before choosing a cleaner. An isolated patch of film can call for a separate cleaning step. Start with the method the vehicle and product instructions support.

Keep the installation area clear

Position parts and tools away from the area the arms need to travel. Fit the blades with the service procedure for your vehicle and the kit instructions. After you have returned the arms and removed everything from the glass, wet the windshield and perform a short test while parked. Note any streak at a fixed spot. That gives you a place to recheck the glass or inspect the blade edge.

Sources and next steps

Comment form title